Test your basic knowledge |

Mechanical Properties Of Metals

Subject : engineering
Instructions:
  • Answer 18 questions in 15 minutes.
  • If you are not ready to take this test, you can study here.
  • Match each statement with the correct term.
  • Don't refresh. All questions and answers are randomly picked and ordered every time you load a test.

This is a study tool. The 3 wrong answers for each question are randomly chosen from answers to other questions. So, you might find at times the answers obvious, but you will see it re-enforces your understanding as you take the test each time.
1. Approximately 0.4 times the absolute melting temperature to induce rapid recovery.






2. Greater the degree of deformation - _________ are the recrystallized grains.






3. Reheating - which increases ductility results in recovery - recrystallization and grain growth. This is call ______ and changes material properties.






4. Recrystallization occurs by the nucleation and growth of new grains containing few dislocations.






5. Recrystallization temperature increases with ______ of metals.






6. Because the number of dislocation is greatly reduced - the recrystallized metal has _________ but lower strength.






7. Additional thermal energy permits disloctions to move and form boundaries of a polygonized subgrain structure. From a practical point of view - the principal change in the metal during recovery is the reduction of stresses.






8. Smaller the deformation - _______ the recrystallization temperature.






9. If metal is held at recrystallization temperature long enough - cold worked structure is completely replaced with recrystallized grain structure.






10. Cold worked metals become brittle.






11. Higher the temperature - is the time required for recrystallization.






12. Heating to recovery temperature relieves internal stresses






13. Amount of prior deformation - Temperature and time - Initial grain size - Composition of metal.






14. Formation of sub- grain structure) takes place.






15. Dislocations are moved into _______ configuration.






16. Expansion of nucleus and migration of grains.






17. For Recrystallization - A minimum amount of _______ is needed.






18. Strain energy of cold work is stored as dislocations